TP-Link JetStream T1600G-28TS - Page 233

224
Access:
Defines the access rights of the community.
 re ad-only:
Management right of the Community is
restricted to read-only, and changes cannot be made to
the corresponding View.
 re ad-write:
Management right of the Community is
read-write and changes can be made to the corresponding
View.
MIB View:
Select the MIB View for the community to access.

Community Table
Select:
Select the desired entry to delete the corresponding Community. It
is multi-optional.
Community Name :
Displays the Community Name here.
Access:
Displays the right of the Community to access the View.
MIB View:
Displays the Views which the Community can access.
Operation:
Click the Edit
button to modify the MIB View and the Access right
of the Community, and then click the Modify button to apply.
Note :
The default MIB View of SNMP Community is viewDefault.
Configuration Procedure:
 If SNMPv3 is employed, please take the following steps:
Step Operation Description
1 Enable SNM P function globally. Required. On the SNM P→SNM P Config→Global
Config page, enable SNM P function globally.
2 Create SNMP View. Required. On the SNM P→SNMP Config→SNM P
View
page, create SNMP View of the management
agent. The default View Name is viewDefault and
the default OID is 1.
3 Create SNMP Group. Required. On the SNM P→SNMP Config→SNM P
Group
page, create SNMP Group for SNMPv3 and
specify SNMP Views with various access levels for
SNMP Group.
4 Create SNMP User. Required. On the SNM P→SNMP Config→SNM P
User page, create SNMP User in the Group and
configure the auth/privacy mode and auth/privacy
password for the User.