TP-Link JetStream T1600G-28TS - Page 67

58
On this page, you can configure the LACP feature of the switch.
Choose the menu Switching→LAG→LACP Config to load the following page.
Figure 5-11 LACP Config
The following entries are displayed on this screen:

Global Config
Syste m Priority:
Specify the system priority for the switch. The system prio
rity and
MAC address constitute the system identification (ID). A lower system
priority value indicates a higher system priority. When exchanging
information between systems, the system with higher priority
determines which link aggregation a link belongs
to, and the system
with lower priority adds the proper links to the link aggregation
according to the selection of its partner.

LACP Config
Select:
Select the desired port for LACP configuration. It is multi-optional.
Port:
Displays the port number.
Ad
min Ke y:
Specify an Admin Key for the port. The member ports in a dynamic
aggregation group must have the same Admin Key.