61
The following entries are displayed on this screen:
: Allows you to Enable/Disable refreshi
: Enter a value in seconds to specify the refresh interval.
1/LAGS: Click 1 to show the information of the physical ports. Click LAGS
to show the information of the link aggregation groups.
Enter a port number and click the Select button or select
to view the traffic statistics of the corresponding port.
: Displays the details of the packets received on the port.
: Displays the details of the packets transmitted on the port.
Displays the number of good broadcast packets received or
transmitted on the port. The error frames are not counted in.
Displays the number of good multicast packets received or
transmitted on the port. The error frames are not counted in.
Displays the number of good unicast packets received or
transmitted on the port. The error frames are not counted in.
Displays the number of good jumbo packets received or
transmitted on the port. The error frames are not counted in.
Displays the number of the received packets that have a bad
Frame Check Sequence (FCS) with a non-
integral octet
(Alignment Error). The length of the packet is between 64 bytes
Displays the number of the received packets (excluding error
packets) that are less than 64 bytes long.
Displays the number of the received packets (including error
packets) that are 64 bytes long.
of the received packets (including error
packets) that are between 65 and 127 bytes long.
Displays the number of the received packets (including error
packets) that are between 128 and 255 bytes long.
number of the received packets (including error
packets) that are between 256 and 511 bytes long.
Displays the number of the received packets (including error
packets) that are between 512 and 1023 bytes long.
plays the number of the received packets (including error
packets) that are over 1023 bytes.
Displays the number of collisions experienced by a port during
To Next Page
Loading...
