TP-Link JetStream T1600G-28TS - Page 87

78
 Network Diagram
 Configuration Procedure
 Configure switch A
Step Operation Description
1
Create VLAN10 Required. On VLAN→802.1Q VLAN→VLAN Config
page, create a
VLAN with its VLAN ID as 10, owning Port 11 and Port 12, and
configure the egress rule of Port 11 as Untag.
2
Create VLAN20 Required. On VLAN→802.1Q VLAN→VLAN Config
page, create a
VLAN with its VLAN ID as 20, owning Port 11 and Port 12, and
configure the egress rule of Port 11 as Untag.
3
Configure MAC
VLAN 10
On VL AN→M AC V L AN→M AC VLAN
page, create MAC VLAN10 with
the MAC address as 00-19-56-8A-4C-71.
4
Configure MAC
VLAN 20
On VL AN→M AC V L AN→M AC VLAN page, create MAC VLAN2
0 with
the MAC address as 00-19-56-82-3B-70.
5
Port Enable Required. On the VLAN→M AC VL AN→Port Enable
page, select and
enable Port 11 and Port 12 for MAC VLAN feature.
 Configure switch B
Step Operation Description
1
Create VLAN10 Required. On VLAN→802.1Q VLAN→VL AN Config
page, create a
VLAN with its VLAN ID as 10, owning Port 21 and Port 22, and
configure the egress rule of Port 21 as Untag.
2
Create VLAN20 Required. On VLAN→802.1Q VLAN→VLAN Config
page, create a
VLAN with its VLAN ID as 20, owning Port 21 and Port
22, and
configure the egress rule of Port 21 as Untag.