TP-Link JetStream T1600G-28TS - Page 93

84
 Configuration Procedure
 Configure switch A
Step Operation Description
1
Create VLAN10 Required. On VLAN→802.1Q VLAN→VLAN Config
page, create a
VLAN with its VLAN ID as 10, owning Port 12 and Port 13, and
configure the egress rule of Port 12 as Untag
ged and Port 13 as
Tagged.
2
Create VLAN20 Required. On VLAN→802.1Q VLAN→VLAN Config
page, create a
VLA N with
its VLAN ID as 20, owning Port 11 and Port 12, and
configure the egress rule of Port 11 as Tagged Port 12 as Untagged.
 Configure switch B
Step Operation Description
1
Create VLAN10 Required. On VLAN→802.1Q VLAN→VLAN Config
page, create a
VLA N with its V
LAN ID as 10, owning Port 3 and Port 4, and configure
the egress rule of Port 3 as Untagged and Port 4 as Tagged.
2
Create VLAN20 Required. On VLAN→802.1Q VLAN→VLAN Config
page, create a
VLAN with its VLAN ID as 20, owning Port 3 and Port 5, and configure
the egress rule of Port 3 as Untagged and Port 5 as Tagged.
3
Create Protocol
Template
Required. On VLAN→Protocol VLAN→Protocol Template page,
configure the protocol template practically. E.g. the Ether Type of IP
network packets is 0800 and that of Appl
eTalk network packets is 809B.
4
Create Protocol
VLAN 10
On VL AN→Protocol VLAN→Protocol Group
page, create protocol
VLAN 10 with Protocol as IP. Select and enable
Port 3, Port 4 and Port
5 for Protocol VLAN feature.
5
Create Protocol
VLAN 20
On VL AN→Protoco l VLAN→Protocol Group
page, create protocol
VLAN 20 with Protocol as AppleTalk. Select and enable Port 3, Port 4
and Port 5 for Protocol VLAN feature.
Return to CONTENTS