TP-Link TD854W

Error! AutoText entry not defined. Error! AutoText entry not defined. User Guide
36
4.2.3.4 Access control
Choose “Setup→WLAN→Access Control” menu, and you will see the Wireless Access Control
screen (shown in Figure 4-20). Wireless access control function is used to allow or deny the
wireless client’s access to the wireless network by MAC address.
Figure 4-20
 Wireless Access Control Mode: Options are “Disable”, “Allow Listed” and “Deny Listed”. If
the mode is “disable”, it means the wireless access control function is closed; if the mode is
“Allow Listed”, only the client on the list will be able to connect to you access point; if the mode
is “Deny Listed”, these wireless clients on the list will not be able to connect to you access
point. Click Apply Changes to save your configuration.
 MAC Address: Enter the MAC address of the client you want to allow or deny.
 Current Access Control List: Shows the MAC address table you configured, you can delete
it as you need.

Note:
After saving your configuration, you need to click the Save button on the left panel to make your
configuration take effect.
4.2.3.5 Advanced
Choose “Setup→WLAN→Advanced” menu, and you will see the Wireless Advanced Settings
screen (shown in Figure 4-21). You can configure the advanced parameters for your WLAN.