TL-SG2424(config)# show storm-control interface range gigabitEthernet
1/0/4-7
show bandwidth
Description
The show bandwidth command is used to display the bandwidth-limit
information of Ethernet ports.
Syntax
show bandwidth [interface { gigabitEthernet port | range gigabitEthernet
port-list }]
Parameter
port —— The Ethernet port number.
port-list —— The list of the Ethernet ports.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the bandwidth-limit information of port 4:
TL-SG2424(config)# show bandwidth interface gigabitEthernet 1/0/4
101
To Next Page
Loading...
