ipv6 address eui-64
Description
This command is used to manually configure a global IPv6 address with an
extended unique identifier (EUI) in the low-order 64 bits on the interface. Specify
only the network prefix. The last 64 bits are automatically computed from the
switch MAC address. To remove an EUI-64 IPv6 address from the interface,
please use the no ipv6 address eui-64 command.
Syntax
ipv6 address ipv6-addr eui-64
no ipv6 address ipv6-addr eui-64
Parameter
ipv6-addr —— Global IPv6 address with 64 bits network prefix, for example
3ffe::1/64.
Configuration Mode
Interface Configuration Mode (interface vlan)
Example
Configure an EUI-64 global address on the interface with the network prefix
3ffe::1/64
TL-SG2424(config)# interface vlan 1
TL-SG2424(config-if)# ipv6 address 3ffe::1/64 eui-64
ipv6 address
Description
This command is used to manually configure a global IPv6 address on the
interface. To remove a global IPv6 address from the interface, please use no
ipv6 address command.
Syntax
ipv6 address ipv6-addr
no ipv6 address ipv6-addr
Parameter
ipv6-addr —— Global IPv6 address with network prefix, for example 3ffe::1/64.
86
To Next Page
Loading...
