TP-Link TL-SG2216 - Power Inline Supply; Power Inline Profile

system power limit, the PD linked to the port with lower priority will be
disconnected. By default, the priority level is “low”.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Configure the PoE priority as “low” for port 2:
TL-SG2424P(config)# interface gigabitEthernet 1/0/2
TL-SG2424P(config-if)# power inline priority low
power inline supply
Description
The power inline supply command is used to configure the PoE status of the
corresponding port.
Syntax
power inline supply { enable | disable }
Parameter
enable | disable —— The PoE status of the port. By default, the PoE status is
“enable”.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable the PoE feature for port 2:
TL-SG2424P(config)# interface gigabitEthernet 1/0/2
TL-SG2424P(config-if)# power inline supply enable
power inline profile
Description
The power inline profile command is used to bind a PoE profile to the
corresponding port. To cancel the bind relation, please use no power inline
profile command.
136