Chapter 1 Using the CLI
1.1 Accessing the CLI
You can log on to the switch and access the CLI by logging on to the switch remotely by a Telnet or
SSH connection through an Ethernet port.
1.1.1. Logon by Telnet
To log on to the switch by a Telnet connection, please take the following steps:
1. Click Start → Run to open the Run window, and type in telnet 192.168.0.1 in the prompt Run
window as Figure 1-1 and click OK.
Figure 1-1 Run Window
2. Type in the User name and Password (the factory default value for both of them are admin)
and press the Enter button to enter User EXEC Mode , which is shown as Figure 1-2.
Figure 1-2 Log in the Switch
3. Type in enable command to enter Privileged EXEC Mode.
Figure 1-3 Enter into Priviledged EXEC Mode
4
To Next Page
Loading...
