TP-Link TL-SG2216 - Ipv6 Mld Snooping Filter(Global); Ipv6 Mld Snooping Filter(Interface)

Example
Specify the source address which sends the Query message as fe80::1234 on
VLAN 2:
TL-SG2424(config)# ipv6 mld snooping querier vlan 2 query-source
fe80::1234
ipv6 mld snooping filter(global)
Description
The ipv6 mld snooping filter command is used to configure the multicast
group filter entries in the format of ip-range. To disable the filter entry, please
use no ipv6 mld snooping filter command.
Syntax
ipv6 mld snooping filter filter-id start-ipv6 end-ipv6
no ipv6 mld snooping filter filter-id
Parameter
filter-id —— Specify the filter ID, ranging from 1 to 30.
start-ipv6 —— Start IPv6 multicast address of the filter entry.
end-ipv6 —— End IPv6 multicast address of the filter entry.
Command Mode
Global Configuration Mode
Example
Create filter entry with filter ID as 2, start IP as ff80::1234 and end IP as
ff80::1235:
TL-SG2424(config)# ipv6 mld snooping filter 2 ff80::1234 ff80::1235
ipv6 mld snooping filter(interface)
Description
The ipv6 mld snooping filter command is used to enable the filter function on
the interface. To disable the filter function, please use no ipv6 mld snooping
filter command.
Syntax
ipv6 mld snooping filter
no ipv6 mld snooping filter
Command Mode
Interface Configuration Mode
179