TP-Link TL-SG2216 - Lldp Transmit; Lldp Snmp-Trap

Syntax
lldp receive
no lldp receive
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable port 1 to receive LLDPDU:
TL-SG2424P(config)# interface gigabitEthernet 1/0/1
TL-SG2424P(config-if)# lldp receive
lldp transmit
Description
The lldp transmit command is used to enable the designated port to transmit
LLDPDU. To disable the function, please use no lldp transmit command.
Syntax
lldp transmit
no lldp transmit
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable port 1 to transmit LLDPDU:
TL-SG2424P(config)# interface gigabitEthernet 1/0/1
TL-SG2424P(config-if)# lldp transmit
lldp snmp-trap
Description
The lldp snmp-trap command is used to enable the port’s SNMP notification. If
enabled, the port will notify the trap event to network management system. To
disable the ports' SNMP notification, please use no lldp snmp-trap command.
208