<Signal-Beep>
ON: 1 OFF: 0
Signal beep
Performing a zero or a measurement takes 8 seconds. The photometer indicates the end of
zeroing or measuring by a short beep.
Press [MODE], [Shift] + [1][4] keys.
Confirm with [ ] key.
The display shows:
•
Press [Shift] +[0] keys to switch the signal beep off.
•
Press [Shift] + [1] keys to switch the signal beep on.
Confirm with [ ] key.
Note:
In the case of methods with reaction periods, an acoustic signal still sounds during the last 10
seconds of the countdown even if the key beep is switched off.
To Next Page
Loading...
