35Trail Tech Voyager
GPS > Log Method:
Log data points after a time interval, or after a
distance interval.
GPS > Log Frequency:
Controls the frequency that data points are
sampled and added to the current track log.
Fast, normal or slow. Fast creates more detailed
files, while slow creates smaller file sizes (but
lower fidelity data.)
GPS > Log Option:
IMPORTANT: This setting can cause Voyager
to not log. If set to “engine sensor” or “wheel
sensor,” then Voyager will not log unless the
sensor sees activity. This is to help create clean
log files, without extra logging done while you
are not moving.
If set to “always,” then Voyager will use GPS
movement to determine when to stop logging.
Because GPS isn’t aware of your vehicle, it has
to wait for you to move a short distance before
turning logging on (thus somewhat less precise
than using sensors attached to the vehicle.)
GPS Settings > Log Option
Menu » Set Menu
Frequency
Fast
Normal
Slow
Time
1 sec
2 sec
5 sec
Distance
1 meter
3 meters
15 meters
To Next Page
Loading...
Need help?
General
