RT-SVD03G-EN 85
Zone Sensor Averaging
In some applications, 1 zone sensor does not give a good representation of zone temperature. The
internal thermistors, 10K ohm resistance @ 25C/77F, can be wired as shown below in order to
provide an average input to the mechanical or programmable Zone Sensor Module BAYSENS106A-
BAYSENS111A/ASYSTAT106-109, ASYSTAT111, BAYSENS019*/AYSTAT666*. If using a
Programmable ZSM, the remote sensor wiring must be twisted/shielded. Connect the shield to
terminal J6-11.
Figure 52. Zone Sensor Averaging
BAYSENS077* BAYSENS077*
BAYSENS077* BAYSENS077*
12 12
12
2
1
To Next Page
Loading...
