Trane ReliaTel - ReliaTel Ventilation Module (RTVM); RTVM Inputs

RT-SVD03G-EN 41
ReliaTel Ventilation Module (RTVM)
RTVM Layout
27.5 to 50 Ton
The RTVM is installed in the economizer section for V3 units with Statitrac.
RTVM Inputs
J1, J2 Inputs:
J1 provides 24VAC power in to the board and MODBUS communication to and from the RTRM. J2
provides 24VAC power and MODBUS communication downstream to the ECA.
J3 Inputs:
J3 - 1, 2 inputs allow configuration for Statitrac Control. If closed, the unit is configured for Statitrac
control.
J4 Inputs:
J4 - 3, 4, 5 provide 5Vdc to the Space Pressure Transducer, an input for the space pressure signal
to the control board, and a common for the transducer.
J5 Output
J5 - 1, 2 provides a 2-10Vdc output signal and common to the exhaust damper actuator.
Figure 19. ReliaTel Ventilation Module (RTVM) Layout
Green
LED
Exhaust Damper Output Common
J-5
Solid On: Communication OK
Blinking: No Communication
Exhaust Damper Output Signal
24 VAC
Common
-
+
ModBus
COMM
Space Pressure
Setpoint
R40
R42
Space Pressure
Setpoint Deadband
Space Pressure input Signal
Space Pressure input Common
+5 Vdc
Common
Pressure Transducer Calibration Output
J4
J9
J11
J3
Cong. Common
Statitrac Cong.
J1
J2