117
Restore To Factory Defaults (Baseline Backup)
At time of manufacture, a “Baseline Backup” of the Symbio 700 is
created. This backup contains the same information as a normal
backup but it can’t be removed from the controller and it can’t be
overwritten. The baseline backs are included in a backup file but will
only be restored onto a controller that doesn’t contain a baseline
backup.
The Baseline Backup is stored on the Symbio 700 and includes all
settings/configuration items at their values as manufactured.
The Baseline Backup can be restored through the Mobile Service Tool
and is intended to be used as a mechanism to restore the controller
to factory defaults.
Once initiated this process cannot be undone and should only be
used if a technician wants to completely “start-over” the setup of a
piece of equipment.
If a controller is replaced in the field, the replacement controller will
not have a baseline backup
Restore to factory defaults restores a baseline backup that is saved on the controller.
Baseline backups are created during the manufacturing process, replacement controllers will not have a
baseline backup.
When there isn’t a baseline backup the button will be greyed out.
When the baseline backup restore is complete the user is disconnected from the controller and taken to
the unit list.
To Next Page
Loading...
