Trane Symbio 700 - Adding Electric Heat to a Symbio Air Handler Paired with a Symbio Condenser

43
Adding Electric Heat to a Symbio Air Handler paired with a Symbio Condenser
Set the Options Board address to 75.
Power up.
Add Electric Heat in the Symbio 700 Configuration by using one of the methods below.
Using the On-Board menu
Go to Home, Utilities, Edit Configuration, Primary Heat for TTA’s, Secondary Heat for TWA’s.
Using the Phone App
Go to View Configuration, EDIT, Primary Heat for TTA’s, Secondary Heat for TWA’s.
If the Options Board was powered up before setting the address, do an IMC Reset with the Phone App.
Go to Service, IMC Link Reset