Trane Symbio 800 Control Upgrade Kit User Manual

4 CDUB-SVN001B-EN
Table of Contents
Other Required Manuals . . . . . . . . . . . . . . . . 3
Required Tools . . . . . . . . . . . . . . . . . . . . . . . . 3
Field-Provided Material . . . . . . . . . . . . . . . . . 3
General Information . . . . . . . . . . . . . . . . . . . . . 5
About This Manual . . . . . . . . . . . . . . . . . . . . 5
Unit Model Number . . . . . . . . . . . . . . . . . . . . 5
Model Number Descriptions . . . . . . . . . . . . . . 6
Getting Started . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Nameplate . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Symbio 800 AdaptiView Display Upgrade Kit
Contents
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Running the IPC Bus . . . . . . . . . . . . . . . . . 8
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Check the Configuration and Set-Points in the
DynaView Display . . . . . . . . . . . . . . . . . . 10
Save the DynaView Configuration and Set-
Points . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Remove the Existing Control Panel Door . 11
Install New Control Panel Door and Symbio
800 Controller
. . . . . . . . . . . . . . . . . . . . . . . . 11
Choosing Display Arm Mounting Location 12
Alternative mounting location: . . . . . . . . 13
Mounting Display Arm . . . . . . . . . . . . . . . . 13
Adjusting the Tracer AdaptiView Display Arm
14
Install Power Supplies and Hardware . . . 15
Install 1A2 Power Supply—CH530 If Not Al-
ready Present . . . . . . . . . . . . . . . . . . . . . . 15
Install 1A2 Power Supply - CH531 Prebuilt
Panels . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
Install Quad Relay Output LLID—CH530 If Us-
ing Chiller Control Sequence 1 . . . . . . . . 16
Install Communication Cable Between 1A1
and 1A2 Power Supplies . . . . . . . . . . . . . 16
Connect Input Power Wiring to 1A2 Power
Supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
Routing New Wire Into and Out of the Control
Panel Enclosure . . . . . . . . . . . . . . . . . . . . 17
Wiring Connections to the Display and Sym-
bio 800 Controller . . . . . . . . . . . . . . . . . . . 17
Solid State Oil Heater Relay Installation . 20
Mounting Location . . . . . . . . . . . . . . . . . . 20
Installation . . . . . . . . . . . . . . . . . . . . . . . . .21
Install Options . . . . . . . . . . . . . . . . . . . . . . . .22
LON Option Installation . . . . . . . . . . . . . . .22
Communication Option . . . . . . . . . . . . . . .22
Communication Device Mounting . . . . . .23
Water Flow Measurement Options . . . . . .24
Energy Meter Option Installation . . . . . . .25
Expansion Module Option . . . . . . . . . . . . .26
Before Restoring System Power . . . . . . . .27
Restoring System Power . . . . . . . . . . . . . .27
Programming . . . . . . . . . . . . . . . . . . . . . . . . . . .28
Programming the Symbio 800 AdaptiView 28
Start-Up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .31
Wiring Diagrams . . . . . . . . . . . . . . . . . . . . . . . .32

Trane Symbio 800 Control Upgrade Kit Specifications

General

Brand	Trane
Model	Symbio 800 Control Upgrade Kit
Category	Monitor
Language	English