CDUB-SVN001B-EN 31
Start-Up
1. When the programming is completed and saved, shut
down power to the control panel and disconnect the
USB cable from the door of the control panel.
2. Reconnect the wire removed from the J2-1 on
the 1A13
LLID.
3. Restore power to the control panel.
The chiller is now ready for normal startup and
che
ckout procedures.
If you have further questions, contact Trane Global Parts
T
echnical Services. To contact them, send a message to
ATechnicalService@trane.com.
To Next Page
Loading...
