[32] Set digital out A low
[33] Set digital out B low
[34] Set digital out C low
[35] Set digital out D low
[36] Set digital out E low
[37] Set digital out F low
[38] Set digital out A high
[39] Set digital out B high
[40] Set digital out C high
[41] Set digital out D high
[42] Set digital out E high
[43] Set digital out F high
[60] Reset Counter A
[61] Reset Counter B
[70] Start Timer 3
[71] Start Timer 4
[72] Start Timer 5
[73] Start Timer 6
[74] Start Timer 7
23-04 Occurrence
Array [10]
Option: Function:
Select the day(s) to which the timed action applies. Specify working/non-
working days in par.0-81
Working Days, par.0-82 Additional Working
Days and par.0-83 Additional Non-Working Days.
[0] * All days
[1] Working days
[2] Non-working days
[3] Monday
[4] Tuesday
[5] Wednesday
[6] Thursday
[7] Friday
[8] Saturday
[9] Sunday
Wear and tear calls for periodic inspection and service of elements in the application, e.g., motor bearings,
feedback sensors and seals or filters. Using preventive maintenance, service intervals may be programmed into
the adjustable frequency drive. The adjustable frequency drive will give a message when maintenance is re-
quired. Twenty preventive maintenance events can be programmed into the adjustable frequency drive. The
following must be specified for each event:
TR200 Programming Guide 4-195
To Next Page
Loading...
