Trane TR200 - Page 97

[55] DigiPot Increase Uses the input as an INCREASE signal to the Digital Potentiometer func-
tion described in parameter group 3-9*
[56] DigiPot Decrease Uses the input as a DECREASE signal to the Digital Potentiometer func-
tion described in parameter group 3-9*
[57] DigiPot Clear Uses the input to CLEAR the Digital Potentiometer reference described
in parameter group 3-9*
[60] Counter A (up) (Terminal 29 or 33 only) Input for increment counting in the SLC counter.
[61] Counter A (down) (Terminal 29 or 33 only) Input for decrement counting in the SLC counter.
[62] Reset Counter A Input for reset of counter A.
[63] Counter B (up) (Terminal 29 and 33 only) Input for increment counting in the SLC coun-
ter.
[64] Counter B (down) (Terminal 29 and 33 only) Input for decrement counting in the SLC coun-
ter.
[65] Reset Counter B Input for reset of counter B.
[66] Sleep Mode Forces the adjustable frequency drive into sleep mode (see par. 22-4*).
Reacts on the rising edge of signal applied!
[78] Reset Preventive Mainte-
nance Word
Resets all data in par.16-96
Maintenance Word to 0.
5-10 Terminal 18 Digital Input
Option: Function:
[0] No operation
[1] Reset
[2] Coast inverse
[3] Coast and Reset Inv
[5] DC brake inverse
[6] Stop inverse
[7] External interlock
[8] * Start
[9] Latched start
[10] Reverse
[11] Start reverse
[14] Jog
[15] Preset reference on
[16] Preset ref bit 0
[17] Preset ref bit 1
[18] Preset ref bit 2
[19] Freeze reference
[20] Freeze output
[21] Speed up
[22] Slow
[23] Set-up select bit 0
[24] Set-up select bit 1
[34] Ramp bit 0
[36] Mains failure inverse
Parameter Description
4-60 TR200 Programming Guide