24
5. Repeat Step 3 and 4 until all four values are programmed. If you do not wish to utilize a set
point, then please set its value to zero. The indicator returns to normal operating mode at the
completion of the programming sequence.
PROGRAMMING OVER/UNDER VALUES
For certain applications, (see next section) the indicator supports one ‘over’ value and one ‘under’
value. The values are retained in memory even after the unit is powered off.
1. Press the Under key. The display shows “ PASS_” to indicate that you need to enter a
password to access this programming mode.
2. Key-in the front panel access password (programmed thru B5) and then press the Enter key.
The display will show the currently stored ‘under’ value.
3. If the displayed value is correct, simply press the ENTER or C/CE key to escape.
4. If the displayed value needs to be changed, use the front panel numeric keys to key-in the
new value and then press ENTER. If you make a mistake, press the C/CE key as a backspace
key. The display will display “SET” briefly and then return to normal operating mode.
5. Press the Over key. The display shows “ PASS_” to indicate that you need to enter a
password to access this programming mode.
6. Repeat Step 2 thru 4 for the ‘over’ value.
To Next Page
Loading...
