Transcell Technology TI-1680 - Truck Weigh In;Weigh out Application (F30 = 8)

30
TRUCK WEIGH IN/WEIGH OUT APPLICATION (F30 = 8)
12
The truck weigh in/weigh out application is designed for weighing material being loaded or unloaded
on a vehicle. The TI-1680 will allow for up 256 individual vehicles to be weighed in & out.
All instructions can be found below. After a successful operation, the indicator will automatically
revert back to normal operating mode.
Use the C/CE key at any time to exit a function. If no key entry is made within a few seconds, the
indicator automatically reverts back to normal operating mode.
Truck In
1. With the truck on the scale, press the F1 key. “Ent Id” will be displayed.
2. Press the Enter key to automatically assign an ID number and then press Enter.
Alternately, you can use the 0-9 keys to key-in in the vehicle ID number (up to 999999) and
then press Enter.
The indicator will display “In”.
3. If a printer is connected, a ticket will automatically be printed.
Truck Out
1. With the truck on the scale, press the F1 key. “Ent Id” will be displayed.
2. Use the 0-9 keys to key-in in the vehicle ID number (up to 999999) and then press Enter.
The indicator will display “Out”.
3. If a printer is connected, a ticket will automatically be printed.
Print all ID numbers
1. Press the ID key. The indicator will display “Prt Id”.
2. Press the Enter key to print all stored ID numbers.
Clear one ID number
1. Press the Under key. The indicator will display “CLr Id”.
2. Press the Enter key to begin.
3. Use the 0-9 keys to key-in the ID number you wish to delete and then press the Enter key. The
ID number will be deleted.
Clear all ID numbers
1. Press the Over key. The indicator will display “CLrALL”.
2. Press the Enter key. All ID numbers will be deleted.
Duplicate print-out
1. Press the Print key. The last ticket will be re-printed.
Continued =>
12
Appears on Version 2.4 and above only