31
Truck In – Store keyboard tare weight
NOTE: First make sure F38 (permanent tare) is set to ‘1’
1. With the truck on the scale, press the F1 key. “Ent Id” will be displayed.
2. Use the 0-9 keys to key-in an ID number and then press the Tare key.
The indicator will display “In” and “TArE”.
3. Press the Enter key. The indicator will display “Ent tr”.
4. Use the 0-9 keys to key-in the tare weight and then press Enter. The tare weight is now saved.
5. If a printer is connected, a ticket will automatically be printed.
Truck In - Store current weight as the tare weight
NOTE: First make sure F38 (permanent tare) is set to ‘1’
1. With the truck on the scale. Press the F1 key. “Ent Id” will be displayed.
2. Use the 0-9 keys to key-in an ID number and then press the Tare key.
The indicator will display “In” and “TArE”.
3. Press the Tare key. The indicator will display the current weight.
4. Press [Enter]. The indicator will display “SEt”. The tare weight is now saved.
5. If a printer is connected, a ticket will be printed.
Truck Out - Using Stored Tare Weight
NOTE: First make sure F38 (permanent tare) is set to ‘1’
1. With the truck on the scale, press the F1 key. “Ent Id” will be displayed.
2. Use the 0-9 keys to key-in an ID number and then press the Enter key.
The indicator will display “Out”.
3. If a printer is connected, a ticket will be printed.
LEGAL FOR TRADE SEALING
Indicators can be sealed for commercial (Legal for Trade) applications as follows.
1. On the back of the indicator, locate the setup/calibration switch cover.
2. Thread a wire security seal through both drilled head screws securing the calibration switch cover
as well as the single drilled head screw holding on the rear panel.
To Next Page
Loading...
Need help?
General
