5 INSTALLING THE REAR BRAKE
TOOLS AND MATERIALS REQUIRED
• Torx T10 for wedge
set screws
• 9mm wrench
• Cable cutter
• Pliers
• M46 countersunk bolt for
housing stop
• Ferrule with integrated liner
• RB brake wedge
• Rear brake cover
(with 2 M3 bolts)
1. Pull the rear brake cable slightly out of the lever.
REAR BRAKE
CABLE
2. With the handlebar rotated all the way to the
right, cut the rear brake housing so that it extends
20mm out the back of the seat tube.
20mm
3. Finish the end of the housing.
Make sure there are no sharp
ends to rub the brake cable.
4. Install the end cap
with integrated liner.
5. Fully seat the brake cable
head in the lever.
6. Pass the brake cable and lined end cap into the
rear brake housing stop.
7. Push the excess housing back into the frame until
the hook feature of the housing stop engages the
bottom of the slot on the inside of the frame.
HOOK FEATURE
8. Install the M4 countersunk bolt.
9. Install the spring shoulder bolt, then proceed
with the same assembly steps used in the setup
of the front brake, including wedge installation
and brake adjustment.
16
To Next Page
Loading...
