TEW-823DRU
28
© Copyright 2014 TRENDnet. All Rights Reserved.
4 Click Add to add the stac route. The stac route informaon appears on the Stac
Route List secon.
ÍNote: To discard the changes, click Cancel.
Delete a Route
To delete a route, check the box in the No. column to select which routes to delete, then
click Delete.
Enable Dynamic Roung
Advanced > Setup > Roung
You may want set up your router to route computers or devices on your network to other
local networks through other routers. Generally, dierent networks can be determined by
the IP addressing assigned to those networks. Generally speaking and for the case of an
example, your network may have 192.168.10.x IP addressing and another network may
have 192.168.20.x IP addressing and because the IP addressing of these two networks are
dierent, they are separate networks. In order to communicate between the two separate
networks, stac roung needs to be congured. If you have other roung devices that
support dynamic roung protocol, you can enable these roung protocols on your router
to learn and automacally generate the routes needed between these networks.
ÍNote: Conguring this feature assumes that you have some general networking
knowledge.
1 Log into your router management page (refer to “Log in to Management Page” on page 8).
2 Click on Advanced > Setup > Roung.
3 In RIP secon, do the following:
Enable RIP: Click the drop-down list to enable or disable RIP dynamic roung protocol.
RIP mode: Depending on which RIP version dynamic roung protocols your other
roung devices support, click the appropriate version v1 or v2.
ÍNote: If selecng RIP v2, this requires basic password authencaon between
roung devices using this protocol. The password must match on all roung
devices connected in order successfully exchange roung informaon.
4 Click Apply to save the changes.
ÍNote: To discard the changes, click Cancel.
The current roung table is visible in Roung Table secon.
To Next Page
