TEW-823DRU
48
© Copyright 2014 TRENDnet. All Rights Reserved.
Appendix
Regulatory and Safety Informaon
Federal Communicaon Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operaon is subject to the following
two condions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operaon. This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protecon against harmful interference in a residenal installaon.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instrucons, may cause harmful interference
to radio communicaons. However, there is no guarantee that interference will not occur
in a parcular installaon. If this equipment does cause harmful interference to radio or
television recepon, which can be determined by turning the equipment o and on, the
user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separaon between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Cauon: Any changes or modicaons not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
Operaons in the 5.15-5.25GHz band are restricted to indoor usage only.
This transmier must not be co-located or operang in conjuncon with any other antenna
or transmier.
IMPORTANT NOTE:
Radiaon Exposure Statement: This equipment complies with FCC radiaon exposure
limits set forth for an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator & your body.
RoHS
This product is RoHS compliant.
Europe – EU Declaraon of Conformity
This device complies with the essenal requirements of the R&TTE Direcve 1999/5/EC,
2006/95/EC and 2009/125/EC.
Regulaon (EC) No. 1275/2008
Regulaon (EC No. 278/2009
EN60950-1 : 2006 + A11 : 2009 + A1: 2010 + A12: 2011
Safety of Informaon Technology Equipment.
EN 62311: 2008
Assessment of electronic and electrical equipment related to human exposure restricons for
electromagnec elds (0 Hz-300 GHz)
.
EN 300 328 V1.8.1 : (2012-06) Class B
Electromagnec compability and Radio spectrum Maers (ERM); Wideband Transmission
systems; Data transmission equipment operang in the 2,4 GHz ISM band and using spread
spectrum modulaon techniques; Harmonized EN covering essenal requirements under
arcle 3.2 of the R&TTE Direcve
.
EN 301 489-1 V1.9.2 : (2011-09)
Electromagnec compability and Radio Spectrum Maers (ERM); ElectroMagnec
Compability (EMC) standard for radio equipment and services; Part 1: Common technical
requirements
.
EN 301 489-17 V2.2.1 : (2012-09)
Electromagnec compability and Radio spectrum Maers (ERM); ElectroMagnec Compability
(EMC) standard for radio equipment; Part 17: Specic condions for 2,4 GHz wideband
transmission systems, 5 GHz high performance RLAN equipment and 5,8 GHz Broadband Data
Transming Systems.
EN 301 893 V1.7.1 : (2012-06)
Broadband Radio Access Networks (BRAN);5 GHz high performance RLAN;Harmonized EN
covering the essenal requirements of arcle 3.2 of the R&TTE Direcve This device is a 2.4/5G
GHz wideband transmission system (transceiver), intended for use in all EU member states and
EFTA countries, except in France and Italy where restricve use applies.
In Italy the end-user should apply for a license at the naonal spectrum authories in order to
obtain authorizaon to use the device for seng up outdoor radio links and/or for supplying
public access to telecommunicaons and/or network services.
This device may not be used for seng up outdoor radio links in France and in some areas
the RF output power may be limited to 10 mW EIRP in the frequency range of 2454 – 2483.5
MHz. For detailed informaon the end-user should contact the naonal spectrum
authority in
France.