TRENDnet TEW-823DRU - Block All Services; Configure Inbound Filter Rules

TRENDnet User’s Guide
TEW-823DRU
32
© Copyright 2014 TRENDnet. All Rights Reserved.
ÍNote: In the Services Block Rule List secon, you can edit a rule by clicking in the
Edit column next to the rule you would like to edit. To delete the rule, click in the
Delete column next to the rule you would like to delete.
Block All Services
1 Log into your router management page (refer to “Log in to Management Page” on page 8).
2 Click on Advanced > Security > Access Control.
3 In Access Control secon, click the Enable opon.
4 In Add Services Block Rule secon, modify the following values:
 Rule Enable: Checking this opon turns on the Protocol/IP Filter and unchecking
turns it o.
 Rule Name: Enter a name for the Protocol/IP Filter.
 IP Address: Enter the IP address or IP address range to apply the protocol/IP lter. For
example, 192.168.10.1, 192.168.10.0/24 or 192.168.10.1-192.168.10.30.
ÍNote: The lter will not be applied to IP addresses outside of the range specied.
 Schedule (Oponal): Select the pre-dened schedule to apply. The lter will only be
acve during the me period dened in the pre-dened schedule.
ÍNote: Before applying scheduling, please ensure your Time sengs are congured
correctly and you have dened a schedule. Refer to “Set the Date and Time” on
page 42 and “Create Schedules” on page 30 to create a schedule.
5 Click Add to save the rule.
ÍNote: To discard the changes, click Reset.
ÍNote: In the All Services Block Rule List secon, you can edit a rule by clicking in the
Edit column next to the rule you would like to edit. To delete the rule, click in the
Delete column next to the rule you would like to delete.
Congure Inbound Filter Rules
Advanced > Security > Inbound Filter
Inbound Filters allows you to allow or deny a specic range of IP addresses. You can create
a predened range of IP addresses to apply to a specic feature.
ÍNote: You can apply a predened inbound lter to the following features:
ͳ Virtual Server
ͳ Gaming
ͳ Remote Management
1 Log into your router management page (refer to “Log in to Management Page” on page 8).
2 Click on Advanced > Security > Inbound Filter.
3 In Add Inbound Filter Rule, modify the following values:
 Filter Name: Enter a name for the IP address range.
 Rule Acon: Select Allow to allow the specied IP address range or Deny to deny the
specied IP address range.
 IP Address: Enter the IP address. For example, 192.168.1.20-192.168.1.30.
4 Click Add to save the Inbound Filter.
ÍNote: To discard the changes, click Clear.
ÍNote: In the Inbound Filter List, you can edit a rule by clicking in the Edit column
next to the rule you would like to edit. To delete the rule, click in the Delete column
next to the rule you would like to delete.