EasyManua.ls Logo

TRENDnet TEW-823DRU - Check the Installation; Initial Setup; Configure the Computer; Windows 7;8;8.1

TRENDnet TEW-823DRU
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TRENDnet Users Guide
TEW-823DRU
7
© Copyright 2014 TRENDnet. All Rights Reserved.
Check the Installaon
To ensure that all devices are properly connected, check the LED indicators on the front of
your router. For basic installaon, the following LED must be lit:
9 Power LED
9 Internet port LED
The lighted LED indicators vary depending on the type of connecon that you make. Refer
to “Front View” on page 5 for more informaon about the LED indicators.
Inial Setup
Congure the Computer
ÍNote: The following procedures on conguring the network sengs can be used as
general guidelines. It is strongly recommended that you consult your computer or
operang system manufacturer directly for assistance on the proper procedure for
conguring the network sengs.
Windows 7/8/8.1
1 Open Control Panel and click Network and Sharing Center.
2 Click Change Adapter Sengs and right-click the Local Area Connecon icon.
3 Click Properes > Internet Protocol Version 4 (TCP/IPv4).
4 Click Obtain an IP address automacally and click OK.
Windows XP/2000
1 Open Control Panel and double-click the Network Connecon icon.
2 Right-click the Local Area Connecon icon and then click Properes.
3 Click Internet Protocol (TCP/IP) > Properes.
4 Click Obtain an IP address automacally and click OK.
Windows Vista
1 Open Control Panel and click Network and Internet.
2 Click Manage Network Connecons and right-click the Local Area Connecon icon >
Properes.
3 Click Internet Protocol Version (TCP/IPv4) > Properes.
4 Click Obtain an IP address automacally and click OK.
MAC OS 10.4/10.5/10.6
1 From the Apple, drop-down list, select System Preferences.
2 Click the Network icon.
3 From the Locaon drop-down list, select Automac.
4 Select and view your Ethernet connecon. Do one of the following:
In MAC OS 10.4, from the Show drop-down list, select Built-in Ethernet and select
the TCP/IP tab.
In MAC OS 10.5/10.6, in the le column, select Ethernet.

Table of Contents

Other manuals for TRENDnet TEW-823DRU

Related product manuals