© Copyright 2014 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-815DAP
42
Upgrade your access point firmware
Administrator > Upload Firmware
TRENDnet may periodically release firmware upgrades that may add features or fix
problems associated with your TRENDnet access point model and version. To check if
there is a firmware upgrade available for your device, please check your TRENDnet
model and version using the link.
http://www.trendnet.com/downloads/
In addition, it is also important to verify if the latest firmware version is newer than the
one your access point is currently running. To identify the firmware that is currently
loaded on your access point, log in to the access point, click on the Administrator
section and then on the Status. The firmware used by the access point is listed at the
top of this page. If there is a newer version available, also review the release notes to
check if there were any new features you may want or if any problems were fixed that
you may have been experiencing.
1. If a firmware upgrade is available, download the firmware to your computer.
2. Unzip the file to a folder on your computer.
Please note the following:
• Do not interrupt the firmware upgrade process. Do not turn off the device or press
the Reset button during the upgrade.
• If you are upgrade the firmware using a laptop computer, ensure that the laptop is
connected to a power source or ensure that the battery is fully charged.
• Disable sleep mode on your computer as this may interrupt the firmware upgrade
process.
• Do not upgrade the firmware using a wireless connection, only using a wired
network connection.
• Any interruptions during the firmware upgrade process may permanently damage
your access point.
3. Log into your access point management page (see “
Access your access point
management page” on page 7).
4. Click on Administrator and click on Upload Firmware.
5. Depending on your web browser, in the Upload Firmware section, click Browse or
Choose File.
6. Navigate to the folder on your computer where the unzipped firmware file (.bin) is
located and select it.
7. Click Apply. If prompted, click Yes or OK.
To Next Page
Loading...
Need help?
General
