© Copyright 2014 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-815DAP
43
Wireless Client List
Wireless > Station List
You can view the list of active wireless devices currently connected to your access point.
1. Log into your access point management page (see “
Access your access point
management page” on page 7).
2. Click on Wireless, and click on Station List.
• MAC Address: Displays the current MAC address of your wireless client.
• Association Time: Displays the duration time of your wireless client
• IP Address: Displays the current IP address of your wireless client.
• Mode: Displays the current mode your wireless client is connected (11a/b/g/n)
• Rate: Displays the current rate your wireless client has established.
• Signal: Displays the signal strength of your wireless client.
.
Check the access point system information
Administrator > Status
You may want to check the system information of your access point such as IP address
settings, access point mode, wireless and wired network settings, access point wireless
MAC addresses, and firmware version.
1. Log into your access point management page (see “
Access your access point
management page” on page 7).
2. Click on Administrator and click on Status.
System Info
• Firmware Version: The current firmware version your access point is running.
• System Up Time: The duration your access point has been running continuously
without a restart/power cycle (hard or soft reboot) or reset.
To Next Page
Loading...
Need help?
General
