7.
1.
2.
3.
4.
5.
6.
-> The IP address is saved to the x/e-touchPANEL.
7.4.4. Setting an IP address for a network with several x/e-touchPANEL
To establish an Ethernet connection to the x/e-touchPANEL in a network, each panel must be assigned an
individual IP address. The ›Network connection‹ diagram shows an example of an addressing process, see "
".Ethernet interface, p. 99
Connect the PC/laptop and the x/e-touchPANEL via the network switch using network cables.
On the PC/laptop, the following values must be set for the network card to which the switch for the
x/e-touchPANEL is connected:
IP address:192.168.123.10
Subnet mask: 255.255.255.0
Gateway: 192.168.123.1
Set the following values for the first x/e-touchPANEL:
IP address:192.168.123.11
Subnet mask: 255.255.255.0
Gateway: 192.168.123.1
Set the following values for the second x/e-touchPANEL:
IP address:192.168.123.12
Subnet mask: 255.255.255.0
Gateway: 192.168.123.1
Increase the last digit of the IP address if you want to set further x/e-touchPANEL. 255 is the highest possible
number.
To store the IP address in the x/e-touchPANEL, click on the Main menu symbol.
-> The x/e-touchPANEL can be controlled via remote control using a web browser with Java Applet installed.
7.4.5. Setting an IP address for point-to-point connections
A crossed network cable is required for a point-to-point connection of a x/e-touchPANEL to a PC / Laptop.
I NOTICE
Please refer to the Help menu or to your operating system's manual on how to assign a permanent IP address.
The previous chapter explains how to set the IP address in the x/e-touchPANEL, see "Network connection, p. 99
".
I NOTICE
For PCs / laptops with Firewall or other protection software, please contact your IT specialist.
To Next Page
Loading...