Juno Series User Guide 89
Getting Connected 7
4. Enter the name for the connection.
5. From the Select a Modem dropdown list, select
Bluetooth and then tap
Next on the right softkey.
6. If the phone you want to connect to is:
– listed, go to Step 7 below.
– not listed:
a. Tap Add new device. The handheld
searches for other Bluetooth devices and
displays them in the list.
If the handheld’s integrated Bluetooth
radio is turned off, it is now automatically
turned on.
b. From the list of available devices, select the device you want to connect
to and then tap
Next on the right softkey.
c. To pair with the phone, enter a passcode of your choice that you will
easily remember onto the handheld and then tap
Next on the right
softkey.
d. When prompted by the phone, enter the same password and then
accept the connection.
You have now created a partnership between the Juno series handheld and
the phone so that they can communicate.
7. From the My Connections list, select the phone that you want to configure the
connection to.
8. Enter the GPRS access number for the Internet.
Two of the common GPRS access numbers for cellular phones on GSM
networks are *99***1# and *99#. If these access numbers do not work, contact
the cellular phone provider to obtain the appropriate number to use.
Note – You do not need to set up dialling rules or change the Internet connection settings
on the phone. The connection settings you enter on the handheld are passed to the phone
to use for this connection.
9. Tap Next on the right softkey.
10. Unless the phone provider confirmed that you must enter user name, password,
and domain settings to access the Internet, tap
Finish on the right softkey
without entering any information in this screen.
Otherwise:
a. Enter the required information.
b. If the phone provider has told you that you need to change the baud rate or
other settings for the connection, tap
Advanced, configure these settings
and then tap
OK in the top right corner of the screen.
To Next Page
Loading...
General