User's Manual
750 50 0045 03 24
6.2.3 Operations on buffer values
Selection of values
It is possible to select 2 buffer values to perform
calculations between them.
To do this, navigate to the desired value and press the
function key. The value will flash. Select the next value
by navigating and selecting as described above.
Calculation of the difference
By pressing the
key, the difference of the two
selected values is calculated and displayed on the 2nd
display line.
If no buffer value is selected, the displayed value will be
the difference between the maximum and minimum value
contained in the buffer.
Calculation of the average
By pressing the
key, the average of the 2 selected
values is calculated and displayed on the 2nd display
line.
If no buffer value is selected, the displayed value will be
the average of all buffer values.
Calculation of min / max
If no value of the buffer is selected, a simple press on
the
key will determine the minimum value of
the buffer.
Long press (> 2 s) on the
key will determine
the maximum value of the buffer.
6.2.4 Sending buffer data
When the buffer is open, pressing the
key
button sends all buffer values (§ 7).
6.2.5 Clearing the buffer
A long press on the key opposite erases all the values of
the buffer.
Values are cleared when the instrument is turned off.
>2 s
To Next Page
Loading...
Need help?
General
