User's Manual
750 50 0045 03 30
7. DATA TRANSFER AND PRINT-OUT
The instrument offers 2 communication ports:
Mini USB
This connector is placed at the back of the display unit. It
allows a very simple connection to a PC for the
transmission of data, upgrades, diagnosis, etc.
This connector is placed at the back of the height gauge.
It allows a classic connection with external devices
equipped with RS232 interfaces, such as printer or PC. It
is also the port used for wireless communication.
Note:
Measured values will be transferred in identical and
simultaneous manner to both ports.
7.1 USB Connection
A mini-USB cable is required for the connection to a PC,
as well as the communication software
TrimosDataTransfer.
Cable
Cable USB A-Mini B: TA-EL-014 (ref. 332 02 0002)
Software
The software TrimosDataTransfer is freely available on
www.trimos.ch, in the corresponding product section.
Data transfer procedure
1. Start TrimosDataTransfer
2. Connect the instrument to the PC with TA-EL-014
cable and wait for the connection to be established
3. Click on the application to which the data has to be
transferred (i.e. Microsoft Excel)
4. Press
key: the value is displayed at the
place having the focus. Data can also be sent
automatically after each measurement (§ 9).
Format
The format of the value sent corresponds to the numeric
value of the display in ASCII characters.
In diameter / Centerline mode, if both values are sent
simultaneously (§ 9) they are separated by a LF (Line
To Next Page
Loading...
Need help?
General
