Trio CS-2100A - Page 13

CONTROLS AND INDICATORS
(49) Z. AXIS INPUT
External intensity modulation input connector. TTL level
input; intensity increases for increasing positive inputs.
(50) POWER LINE CONNECTOR
The input connector for the AC power cord.
BOTTOM PANEL
(52) TRACE ROTATION
This control is used to compensate for trace rotation distor-
tion.
Once this control is adjusted it needs not be frequently
readjusted.
(53) ASTIG
This control is used to compensate for trace or spot astig-
matism.
Once this control is adjusted it needs not be frequently
readjusted.
(54) Handle
The handle of the CS-2100A can be set to desired angle so
that the CS-2100A is inclined for easy operation. The han-
dle turns in 15 degree steps.
The supplied probe holder can be installed in the metal
portion of the holder.
(55) Feet
Feet support oscilloscope in vertical position (face up) and
serve as cord wrap for storing power cord.
3-6
(51) LINE VOLTAGE SWITCH
This switch is used to select the power supply input volt-
age.
LOW 90 ~ 132VAC
HIGH 180 ~ 264VAC