11
WARNING!
Before normal
operation of the
shower, it is essential
the commissioning
procedure is completed
correctly.
When the start/stop bar is
pressed water will continue
to flow in order to remove
heated water inside the
unit (see phased shutdown
process). Water will cease to
flow after a few seconds.
After phased shutdown the
unit must be isolated via the
45amp-isolating switch.
Note: It is advisable to be
certain that the showering
temperature is satisfactory
by testing with your hand
before stepping under the
showerhead. There will
always be a time delay of
a few seconds between
selecting a flow rate and
the water reaching the
stable temperature for
that flow rate.
To Next Page
Loading...
Need help?
General
