Triton T60X User Manual

17
T60X
OPERATING THE SHOWER
The flow of water is controlled by the
START/STOP temperature control. To obtain
warm water turn the control slowly
anti-clockwise to the mid position, i.e. numbers 5
or 6 (fig.19).
If the water is too hot, turn the temperature
control slowly clockwise towards the lower
numbers (fig.20).
If the water is too cool, turn the temperature
control slowly anti-clockwise towards the higher
numbers (fig.21).
To stop the shower turn the temperature control
fully clockwise to the STOP position and water
will cease to flow.
Power Selector
The power selector has two positions, ECONOMY
and HIGH (fig.22).
The single red symbol is the economy setting
for using less power during warmer months
when the ambient water temperature is high.
NOTE: If the stated flow rate required for the unit
cannot be met due to low water pressure, it will
be necessary to operate the unit on this setting
during the warmer months because of flow rate
limitations entering the unit.
The double red symbol is the high setting
which allows the highest flow achievable for
your preferred temperature. This setting should
be regarded as normal for optimum shower
performance throughout the year.
NOTE: It is advisable to be certain that the
showering temperature is satisfactory by testing
with your hand before stepping under the
shower head.
There will always be a time delay of a few
seconds between selecting a flow rate and the
water reaching the stable temperature for that
flow rate.
Fig.19
Fig.20
Fig.21
C
o
l
d
e
r
H
o
t
t
e
r

Triton T60X Specifications

General

Brand	Triton
Model	T60X
Category	Bathroom Fixtures
Language	English