Triumph Speed Triple R User Manual

27
General Information
Changing Units (Imperial, US
or Metric)
Units has four selectable display modes as
described below:
• mpg - Imperial gallons;
• mpg US - US gallons;
• L/100 km - Metric;
•km/L - Metric.
Each display provides the following
information:
mpg (Imperial gallons)
The speedometer and odometer will read in
miles. The fuel consumption will be
measured in imperial gallons.
mpg US (US gallons)
The speedometer and odometer will read in
miles. The fuel consumption will be
measured in US gallons.
L/100 km (Metric)
The speedometer and odometer will read in
kilometers. The fuel consumption will be
measured in liters of fuel per 100 km.
km/L (Metric)
The speedometer and odometer will read in
kilometers. The fuel consumption will be
measured in kilometers per liter of fuel.
To access the units display, with the
motorcycle stationary and in neutral turn the
ignition to the ON position.
Press and release button 'A' until set up is
visible in the display screen then press
button 'B'.
Press and release button 'A' until UnitS is
visible then press button 'B'.
1. Display screen
2. Button A
3. Button B
Warning
Do not attempt to change the units display
with the motorcycle in motion as this may
lead to loss of motorcycle control and an
accident.
2
3
cfir_12
1

Triumph Speed Triple R Specifications

General

Engine Capacity	1050 cc
Transmission	6-speed
Seat Height	825 mm
Fuel System	Multipoint sequential electronic fuel injection
Engine Type	Liquid-cooled, 12-valve, inline 3-cylinder
Power	148 hp (110 kW) @ 10, 500 rpm
Torque	117 Nm at 7, 150 rpm
Front Suspension	Öhlins 43mm NIX30 upside down forks with adjustable preload, rebound and compression damping
Rear Suspension	Öhlins TTX36 monoshock, fully adjustable
Front Brakes	Twin 320mm floating discs, Brembo 4-piston radial calipers
Fuel Tank Capacity	15.5 litres