Triumph Speed Triple R User Manual

30
General Information
• SE mode: The lights will
progressively illuminate in 250 rpm
increments until the set limit is
reached. At the set limit all six lights
will be illuminated.
Setting Gearshift Light Limits
The gearshift lights will not operate below
3,500 rpm to avoid the lights operating at
idle.
To change the gearshift light modes, with the
motorcycle stationary and in neutral turn the
ignition to the ON position.
Press and release button 'A' until set up is
visible in the display screen then press
button 'B'.
Press and release button 'A' until SHIFt is
visible then press button 'B'. The current
mode will be displayed and the
corresponding gearshift lights will illuminate.
Press and release button 'A' until the desired
gearshift light mode is visible then press
button 'B'. The display will scroll through in
the following order:
•SE (Scale mode);
•3 (3 LED mode);
•6 (6 LED mode);
• OFF (Gearshift lights off).
Note:
• The motorcycle is delivered from
the factory with the gearshift light
set to the 6 LED mode at 3,500
rpm.
1. Gearshift lights
2. Display screen (3 mode shown)
3. Button A
4. Button B
chdo_2
2
4
1
3

Triumph Speed Triple R Specifications

General

Engine Capacity	1050 cc
Transmission	6-speed
Seat Height	825 mm
Fuel System	Multipoint sequential electronic fuel injection
Engine Type	Liquid-cooled, 12-valve, inline 3-cylinder
Power	148 hp (110 kW) @ 10, 500 rpm
Torque	117 Nm at 7, 150 rpm
Front Suspension	Öhlins 43mm NIX30 upside down forks with adjustable preload, rebound and compression damping
Rear Suspension	Öhlins TTX36 monoshock, fully adjustable
Front Brakes	Twin 320mm floating discs, Brembo 4-piston radial calipers
Fuel Tank Capacity	15.5 litres