Triumph Speed Triple R User Manual

37
General Information
When 2 bars are displayed the low fuel
warning light will illuminate. This indicates
there are approximately 4.5 litres of fuel
remaining in the tank and you should refuel
at the earliest opportunity. If a trip meter
display is visible, the range to empty display
can be selected by pressing and releasing
button 'B' until it is visible.
After refuelling, the fuel gauge and range to
empty information will be updated only while
riding the motorcycle. Depending on the
riding style, updating could take up to five
minutes.
Tire Pressure Monitoring
System (TPMS)
(Only on models fitted with TPMS)
Function
Tire pressure sensors are fitted to the front
and rear wheels. These sensors measure the
air pressure inside the tire and transmit
pressure data to the instruments. These
sensors will not transmit the data until the
motorcycle is travelling at a speed greater
than 12 mph (20 km). Two dashes will be
visible in the display area until the tire
pressure signal is received.
Warning
The daily check of tyre pressures must not
be excluded because of the fitment of the
TPMS. Check the tyre pressure when the
tyres are cold and using an accurate tyre
pressure gauge (see page 110 ).
Use of the TPMS system to set inflation
pressures may lead to incorrect tyre
pressures leading to loss of motorcycle
control and an accident.

Triumph Speed Triple R Specifications

General

Engine Capacity	1050 cc
Transmission	6-speed
Seat Height	825 mm
Fuel System	Multipoint sequential electronic fuel injection
Engine Type	Liquid-cooled, 12-valve, inline 3-cylinder
Power	148 hp (110 kW) @ 10, 500 rpm
Torque	117 Nm at 7, 150 rpm
Front Suspension	Öhlins 43mm NIX30 upside down forks with adjustable preload, rebound and compression damping
Rear Suspension	Öhlins TTX36 monoshock, fully adjustable
Front Brakes	Twin 320mm floating discs, Brembo 4-piston radial calipers
Fuel Tank Capacity	15.5 litres