121
Maintenance and Adjustment
Headlight Adjustment Lever for Loaded
Conditions
1. Headlight adjuster lever (unloaded
position)
2. Headlight adjuster lever (loaded
position)
For normal (unloaded) conditions the
headlight adjuster lever should be set in the
horizontal position (1).
For loaded conditions rotate the headlight
adjuster downwards until it stops (2). This will
lower the headlight beams by
approximately 2°.
Headlight Bulb Replacement
It is not necessary to remove the headlight
when bulb replacement becomes necessary.
1. Bulb retainer (right hand shown)
2. Bulb retainer hook
3. Bulb
1
chfb_1
2
The use of non-approved headlight bulbs
may result in damage to the headlight lens.
Use a genuine Triumph supplied headlight
bulb as specified in the Triumph Parts
Catalogue.
Always have replacement headlight bulbs
installed by an authorised Triumph dealer.
The bulbs become hot during use. Always
allow sufficient time for the bulb to cool
before handling. Avoid touching the glass
part of the bulb. If the glass is touched or
gets dirty, clean with alcohol before reuse.
1
2
cgjn
3
To Next Page
