52
General Information
Resuming the Cruise Control Set
Speed
Cruise control will be deactivated if one of the
following actions has been taken:
• Roll the throttle twist grip fully forward;
• Press and release the on/off button on
the right hand switch cube;
• Pull the clutch lever;
• Operate the front or rear brake;
• Increase speed by using the throttle grip
for more than 60 seconds.
The set speed can be resumed by pressing
and releasing the RES/+ end of the adjust
button provided the conditions described on
page 51 have been met.
1. Cruise control ON/OFF button
2. Cruise control adjust button, SET/-
3. Cruise control adjust button, RES/+
The set speed will remain in the cruise control
memory until the ignition switch has been
turned to the OFF position.
When resuming cruise control, always
ensure that the traffic conditions are
suitable for the set speed.
Using cruise control in heavy traffic, on
roads with sharp/blind bends or when they
are slippery, may result in loss of
motorcycle control and an accident.
To Next Page
Loading...
