122
Maintenance and Adjustment
To replace a bulb:
Remove the rider's seat.
Disconnect the battery, negative (black) lead
first.
Remove the bulb cover from the bulb to be
replaced by rotating it anti-clockwise.
Disconnect the multi-plug from the bulb.
Detach the bulb retainer from the hook on
the headlight assembly and rotate it away
from the bulb as shown.
Remove the bulb from the bulb retainer.
Installation is the reverse of the removal
procedure.
Position Lamp Bulb Replacement
1. Fixings
2. Headlight surround
3. Position lamp bulb
The position lamp is fitted to the centre of the
headlight. To replace the bulb, remove the
four fixings and remove the headlight
surround, detach the rubber retainer from
the headlight and pull out the bulb.
Installation is the reverse of the removal
procedure.
Front Fog Lights - If Fitted
Front Fog Light Bulb Replacement
Release the fixings and washers then detach
the fog lamp from its shroud.
1. F i x i n g s
2. Washers
3. Fog lamp
4. Shroud
2
3
1
1
chgn
The bulbs become hot during use. Always
allow sufficient time for the bulb to cool
before handling. Avoid touching the glass
part of the bulb. If the glass is touched or
gets dirty, clean with alcohol before reuse.
Do not allow the fog lamp to hang
unsupported from the harness during bulb
replacement. Allowing the fog lamp to
hang from the harness will cause damage
to the fog lamp.
To Next Page
