29
General Information
Models with TPMS
Press the set button and do not touch the
scroll or set buttons again until PSI or bAr is
displayed. Press and release the scroll button
until the desired tyre pressure units are
visible.
All Models
Press the set button and wait until ºC or ºF is
visible. Press and release the scroll button
until the desired temperature unit is
displayed. Then press the set button and wait
until UnitS is displayed, then press the home
button and the odometer in the trip 1 menu
will be visible in the display screen.
Clock Adjustment
To reset the clock; with the motorcycle
stationary and in neutral turn the ignition to
the ON position. Press and release the set
button on the left hand switch cube until
'SEtUP' is visible in the display screen. Press
and release the scroll button until t-SEt is
visible.
Press the set button again and either 24 Hr
or 12 Hr clock will be shown. Press the scroll
button to select the desired clock display and
then press the set button. The hour display
will start to flash and the word Hour is visible
in the display screen.
Note:
• The hour/minute display will
increase when pressing the up part
of the scroll button or decrease
when pressing the down part of the
button.
To reset the hour display, ensure that the
hour display is still flashing and the word
Hour is visible. Press the scroll button to
change the setting. Each individual button
press will change the setting by one digit. If
the button is held, the display will
continuously scroll through in single digit
increments.
To Next Page
Loading...
