53
General Information
Increasing Speed while in Cruise
Control
To increase the speed, press and release the
RES/+ end of the adjust button. Each press of
the button will increase the speed by 1 mph
or 1 km/h. If the button is held, the speed
continuously increases in single digit
increments. When the desired speed is shown
in the display, stop pressing the adjust button.
1. Display screen
While increasing the speed, the display
screen in the instruments will change to 'SEt',
and will show the new set speed and will
flash until the motorcycle has achieved the
speed.
After 4 seconds the display screen will
change to the previous display.
Note:
• If riding up a steep incline and cruise
control is unable to maintain the set
speed, the instruments will change
to 'SEt', show the set speed and will
flash until the motorcycle has
regained the speed.
An alternative way to increase the speed in
cruise control is to accelerate to the desired
speed using the throttle grip and then press
the SET/- end of the adjust button.
Decreasing Speed while in Cruise
Control
To decrease speed, press and release the
SET/- end of the adjust button. Each press of
the button will decrease the speed by 1 mph
or 1 km/h. If the button is held, the speed will
continuously decrease in single digit
increments.
While decreasing the speed, the display
screen in the instruments will change to SEt
and will show the set speed decreased.
When the desired speed has been achieved,
stop pressing the adjust button. After
4 seconds the display screen will change to
the previous display.
Deactivating Cruise Control
The cruise control can be deactivated by one
of the following methods:
• Roll the throttle fully forward;
• Pull the clutch lever;
• Operate the front or rear brake;
• Increase speed by using the throttle for
more than 60 seconds;
• Press and release the on/off button on
the right hand switch cube.
Provided the cruise control has not been
deactivated by turning the ignition switch to
the OFF position, the previous set speed can
be resumed by pressing and releasing the
RES/+ end of the adjust button. The
motorcycle speed has to be between 30 to
100 mph (48 to 160 km/h) and in 4th gear
or higher.
To Next Page
Loading...
