58
General Information
Rear Seat
1. S e a t l o c k
The seat lock is located on the rear
mudguard, below the rear light unit. To
remove the seat, insert the ignition key into
the seat lock and turn it anti-clockwise while
pressing down on the rear of the seat. This
will release the seat from its lock and allow it
to be slid rearwards for complete removal
from the motorcycle.
To refit the seat, engage the seat's two outer
brackets under the loops on the subframe
and the two inner brackets to brackets on the
rider's seat. Gently push the seat forwards
and press down at the rear to engage in the
seat lock.
1. Rear seat outer brackets
2. Subframe loops
3. Rear seat inner brackets
4. Rider seat brackets
To prevent detachment of the seat during
riding, after fitting always grasp the seat
and pull firmly upwards. If the seat is not
correctly secured, it will detach from the
lock. A loose or detached seat could cause
loss of motorcycle control and an accident.
To Next Page
Loading...
