1.3 Introduction
1.3.1 Original instructions
These instructions are original instructions made by Trojanlabel for the Trojanlabel digital
over-printer T3-OPX.
1.3.2 Purpose
The purpose of these instructions is to ensure correct installation, use, handling and
maintenance of the machine.
1.3.3 Accessibility
The instructions are to be kept in a location known to the staff and must be easily
accessible for the operators and maintenance personnel.
1.3.4 Knowledge
It is the duty of the employer (the owner of the machine) to ensure that anyone who is to
operate, service, maintain, or repair the machine have read the instructions. As a
minimum, they should have read the part(s) relevant for their work. In addition, anyone
who is to operate, service, maintain, or repair the machine is under obligation to look for
information in the instructions themselves.
1.4 General Information
1.4.1 Manufacturer
The machine has been manufactured by:
AstroNova, Inc.
600 E Greenwich Ave
West Warwick, RI 02893
USA
1.4.2 The machine’s designation
The machine’s complete designation is Digital Over-Printer type T3-OPX.
1.4.3 Machine plate
The machine plate is situated on the back side of the machine at the lower left corner:
To Next Page
