True CS900 - User Manual

Questions and Answers

V
Victoria MitchellAug 27, 2025
What to do if my True Treadmill shows Fault SC05: Motor Over Speed?
- M
  Michelle TerryAug 27, 2025
  A 'Motor Over Speed' fault on your True Treadmill can be triggered by a few things. High friction between the belt and deck may be the cause, so lubricating the treadbelt is a good first step. Make sure that the AC line voltage is correct. If the speed sensor is dirty or misaligned, it is best to contact your dealer or TRUE service.
J
julie33Aug 27, 2025
Why does my True Treadmill display Fault SC06: Motor Acceleration Fault?
- S
  steve31Aug 27, 2025
  A 'Motor Acceleration Fault' on your True Treadmill can occur for a few reasons. If the user is holding the belt back, stop doing that. High friction between the belt and deck can also cause this issue, so lubricating the treadbelt may help. If the speed sensor is dirty or misaligned, further assistance may be needed.
W
watsonwillieAug 25, 2025
What to do if my True Treadmill shows Fault SC04: Motor Under Speed?
- Q
  qmartinAug 26, 2025
  If your True Treadmill displays a 'Motor Under Speed' fault, it could be due to several reasons. High friction between the belt and deck is a common cause, so try lubricating the treadbelt. Also, check the tension of both the drive belt and the walking belt. Ensure that the AC line voltage is adequate. If the speed sensor is dirty or misaligned, it is best to contact your dealer or TRUE service.
L
Lisa SmithAug 23, 2025
What does Fault CN08: Calibration Failed - Lower Limit Not Reached mean on True Elliptical Trainer?
- C
  carrollkurtAug 25, 2025
  If you receive a Calibration Failed - Lower Limit Not Reached error on your True Elliptical Trainer, it means the unit is configured as a treadmill. To resolve this, re-configure the console.